Manual

GigaX2008EX L2 Managed Switch User Manual

3 Quick start guide

This section provides the basic instructions to set up the GigaX2008EX working

environment. Refer also to the GigaX2008EX Installation Guide.

Part 1 shows you how to install the GigaX2008EX on a ﬂat surface or on a rack.

Part 2 provides instructions to set up the hardware.

Part 3 shows you how to conﬁgure basic settings on the GigaX2008EX.

Obtain the following information from your network administrator before

proceeding:

IP address for the switch

Default gateway for the network

Network mask for this network

3.1 Part 1 — Install the hardware

Connect the device to the power outlet, and your computer or network.

3.1.1 Install the switch on a ﬂat surface

The switch should be installed on a level surface that can support the weight

of the switches and their accessories. Attach four rubber pads on the marked

location on the bottom of the switch.

3.1.2 Mount the switch on a rack

1. Attach brackets to each side of the switch and make the posts insert to the

switch.

2. Insert and tighten two screws to securely attach the bracket to the rack on

each side.

3.2 Part 2 — Set up the switch

Connect the device to the power outlet, and your computer or network.

3.2.1 Connect the console port

For console management, use an RS232 (DB9) to connect the switch. If you

want to use Web interface, connect your PC to the switch using the Ethernet

cable.