Manual

10
GigaX2008EX L2 Managed Switch User Manual
http://192.168.1.1
This is the factory default IP address of the switch.
A login screen appears, as shown in Figure 6.
Figure 6. Login screen
Enter your user name and password, and then click
OK
to enter the
Configuration Manager. Use the following defaults the first time you log into this
interface:
Default User Name: admin
Default Password: (no password)
You can change the password at any time (see section 5.3.1
System Commands).
3. To setup a new IP address, click
System
, then
IP Setup
(see Figure 7). Fill
in the IP address, network mask and default gateway, then click
OK
.
4. If your new address is different from the default, the browser cannot update
the switch status window or retrieve any page. This is normal. You have to
retype the new IP address in the address/location box, and press
<Enter>
.
The WEB link returns.
5. To enable authentication for Web access, click
Administration
on the menu
list, then select
Enabled
to start the protection.
A login window appears immediately after you click
OK
.
Figure 7. IP setup