Manual

29
GigaX2008EX L2 Managed Switch User Manual
4.7.3 RADIUS
In order to use external RADIUS server, the following parameters are required to
be setup:
Authentication Server IP:
The IP address of the RADIUS server.
Authentication Server Port:
The port number for the RADIUS server is
listening to.
Authentication Server Key:
The key is used for communications between
GigaX and the RADIUS server.
Confirm Authentication Key:
Re-type the key entered above.
The VLAN of the RADIUS server connected to the switch must
be the same as the VLAN of the system management interface.
Please click
OK
to make the settings permanent. Click
Relaod
to refresh the
settings to current value.
Figure 31. RADIUS
4.8 Power over Ethernet (PoE)
PoE provides a way to distribute low-voltage power across the network
using existing copper Ethernet cable to an endpoint PD (Powered Device).
This centralized, reliable source of power allows network devices such as
IP telephones, wireless LAN access points, surveillance cameras, and other
embedded appliances to operate without additional power adapters or AC
outlets. You can configure the port power as follows:
Port:
select the port to configure
Port State:
enable/disable the port power
Priority:
set the port priority. Low numeric value indicates a high priority.
Assigning the same priority to different ports will arrange the ports according
to their physical order, with the lower numeric port having the highest priority.
The valid value is from 0 to 47.
Port Status Window:
displays the following information for each port