Manual

38
GigaX2008EX L2 Managed Switch User Manual
CLI command:
net interface vlan sw0 <VLAN ID>
[IP Address]
Displays the static IP address for the switch. This IP address is used for
manageable purpose, i.e.; network applications such as, http server, SNMP
server, ftp server, telnet server and SSH server of the switch are all using this IP
address.
CLI command:
net interface ip sw0 < IP address> <netmask>
[Network Mask]
Displays the subnet mask for the switch.
CLI command:
net interface ip sw0 < IP address> <netmask>
[Default Gateway]
Displays the IP address of the default gateway. This field is necessary if the
switch network contains one or more routers.
CLI command:
net route static add <destination subnet/IP> <gateway>
<netmask> <metric>
[Password Protection is]
[Enabled/Disabled]
When the password protection is enabled, the web interface will request a user
name and password authentication while user accesses the switch through the
browser.
CLI command:
sys web set <enable/disable>
[New Password] / [Verify Password]
The default user name is admin. By default, a password is not required. You
may set a password by configuring these fields.
CLI command:
sys users modify <user name, ʻadminʼ by default>
user name
(old user name, ʻadminʼ by default): <new user name>
password
(old password,): <new password>
[Reboot]
User can reboot the switch by issuing the reboot command.
CLI command:
sys reboot
[Upload]
No CLI command for this function. Refer to Boot ROM commands for this function.