User Manual

55
GigaX2024B L2 Managed Switch User Manual
Figure 59. Boot ROM command mode
5.1.2 Boot ROM commands
The followings are two types of boot ROM commands,
• command: The current settings will be displayed.
• command with new setting: The current setting will be replaced by specified
new setting.
Command Parameters Usage Notes
baudrate Baud rate 9600, 38400,
57600, 115200
You need to set up the terminal
emulatror with the same baut rate
ethaddr none none get MAC address
gatewayip IP address xxx.xxx.xxx.xxx set gateway IP address
go none none boot firmware image
? or help none none print online help
ipaddr IP address xxx.xxx.xxx.xxx set TFTP client IP address
xload none none load binary file over serial line (X
modem)
netmask mask xxx.xxx.xxx.xxx set network mask
ping host xxx.xxx.xxx.xxx send ICMP echo_request to host
pwd none none reset switch password
serverip IP address xxx.xxx.xxx.xxx set TFTP server IP address
slot slot 1, 2, auto select boot slot
tftpboot filename xxx.img load image via network with TFTP
version none none print monitor version