User's Manual

ASUS H110M-CS
1-3
Intel
®
H110 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
TheseconnectorsconnecttoSerialATA6.0Gb/sharddiskdrivesviaSerialATA
6.0Gb/ssignalcables.
System panel connector (10-1 pin F_PANEL)
Thisconnectorsupportsseveralchassis-mountedfunctions.
PIN 1
PWR BTN
GND
PWR
PWR_LED-
PWR_LED+
(NC) HWRST# Ground HDD_LED- HDD_LED+
F_PANEL
+PWR_LED-
+HDD_LED- RESET
Chassis intrusion header (4-1 pin CHASSIS)
Thisheaderisforachassis-mountedintrusiondetectionsensororswitch.
Connectoneendofthechassisintrusionsensororswitchcabletothisheader.
Thechassisintrusionsensororswitchsendsahigh-levelsignaltothisheader
whenachassiscomponentisremovedorreplaced.Thesignalisthengenerated
asachassisintrusionevent.
Bydefault,thepinlabeled“ChassisSignal”and“Ground”areshortedwitha
jumpercap.Removethejumpercapsonlywhenyouintendtousethechassis
intrusiondetectionfeature.
Speaker connector (4-pin SPEAKER)
This4-pinconnectorisforthechassis-mountedsystemwarningspeaker.The
speakerallowsyoutohearsystembeepsandwarnings.
PCI Express 3.0/2.0 x16 slot
ThismotherboardsupportsPCIExpress3.0/2.0x16graphiccardscomplyingwith
thePCIExpressspecications.
Clear RTC RAM (2-pin CLRTC)
ThisheaderallowsyoutocleartheCMOSRTCRAMdataof
thesystemsetupinformationsuchasdate,time,andsystem
passwords.
To erase the RTC RAM:
1. TurnOFFthecomputerandunplugthepowercord.
2. Useametalobjectsuchasascrewdrivertoshortthetwo
pins.
3. PlugthepowercordandturnONthecomputer.
4. Holddownthe<Del>keyduringthebootprocessand
enterBIOSsetuptore-enterdata.
CLRTC
+3V_BAT GND
PIN 1
Ifthestepsabovedonothelp,removetheonboardbatteryandshortthe
twopinsagaintocleartheCMOSRTCRAMdata.AfterclearingtheCMOS,
reinstallthebattery.