User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- 3.1 BIOS setup program
- 3.1.1 BIOS menu screen
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 Power Management
- 3.3.7 PCI Express Configuration
- 3.3.8 Super IO Configuration
- 3.3.9 Serial Console Redirection
- 3.3.10 SATA Configuration
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 IO Expander Configuration
- 3.3.18 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- 3.1 BIOS setup program
- Appendix
H610I-EM-A
2-20
8. Speaker header (4-pin SPEAKER)
The 4-pin header is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
+5V
GND
GND
Speaker Out
SPEAKER
PIN 1
Connector type
HEADER 1x4p, 2.54mm pitch, S/T
9. Chassis Intrusion header (4-1 pin_CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a low-level signal
to this connector when a chassis component is installed. The signal is then
generated as a chassis intrusion event.
Connector type
HEADER 4p, K2, 2.54mm pitch
PIN 1
+5VSB_MB
Chassis Signal
GND
CHASSIS