User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- 3.1 BIOS setup program
- 3.1.1 BIOS menu screen
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 Power Management
- 3.3.7 PCI Express Configuration
- 3.3.8 Super IO Configuration
- 3.3.9 Serial Console Redirection
- 3.3.10 SATA Configuration
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 IO Expander Configuration
- 3.3.18 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- 3.1 BIOS setup program
- Appendix
H610I-EM-A
2-22
NOTE: The serial port cable is purchased separately.
12. COM Port headers (10-pin COM3 - COM6)
These headers are for serial (COM) ports. Connect the serial port cables to
these headers, then install the module to a slot opening at the back of the
system chassis.
COM3
COM4
COM5
A
B
C
COM6
D
PIN 1
PIN 2
PIN 9
Ring
RTS#
GND
TXD
DCD#
CTS#
DSR#
DTR#
RXD
PIN 1
PIN 2
PIN 9
DCD#
TXD
GND
RTS#
Ring
RXD
DTR#
DSR#
CTS#
A B C
D
Connector type
HEADER 2x5p, K10, 2.54mm pitch
13. RTC Battery header (2-pin BATTERY)
This header is for the lithium CMOS battery.
+BAT
GND
BATTERY
PIN 1