User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Configuration
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Devices Configuration
- 3.3.13 APM Configuration
- 3.3.14 EzFlash
- 3.3.14 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
H610M-IM-A
2-22
NOTE: The serial port cable is purchased separately.
14. COM Port headers (10-pin COM3 - COM6)
These headers are for serial (COM) ports. Connect the serial port cables to
these headers, then install the module to a slot opening at the back of the
system chassis.
COM3
PIN 1
DCD#
TXD
GND
RTS#
Ring
RXD
DTR#
DSR#
CTS#
A
B
A
COM4
B
COM5
C
COM6
D
C D
Connector type
Header 2x5p, K10, 2.54mm pitch
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
13. USB 2.0 headers/connector (10-pin USB56, USB78 / USB9, USB9)
These headers/connector are for USB 2.0 ports. Connect the USB cables to
the headers/connector. The USB headers/connector comply with USB 2.0
specication that supports up to 480 Mbps connection speed.
B
USB_78
C
USB9
USB+5V
USB_P7-
USB_P7+
GND
NC
USB+5V
USB_P8-
USB_P8+
GND
PIN 1
PIN 1
USB+5V
S_USB_PN9
S_USB_PP9
GND
A
USB_56
USB+5V
USB_P5-
USB_P5+
GND
NC
USB+5V
USB_P6-
USB_P6+
GND
PIN 1
A B C
Connector type
Header 2x5p, K9, 2.54mm pitch