User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Configuration
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Devices Configuration
- 3.3.13 APM Configuration
- 3.3.14 EzFlash
- 3.3.14 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
H610M-IM-A
2-16
CAUTION: Do not forget to connect the fan cables to the fan headers.
Insufcient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
headers!
3. CPU and Chassis Fan headers (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan headers on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the header.
CHA_FAN
A
GND
CHA FAN PWR
CHA FAN IN
CHA FAN PWM
B
A
CPU_FAN
B
GND
CPU FAN PWR
CPU FAN IN
CPU FAN PWM
Connector type
WAFER HD 4p, 2.54mm pitch, S/T
NOTES:
• The M.2 SSD module is purchased separately.
• This slot supports M Key and 2242/2260/2280 storage devices.
4. M.2 slot (SOCKET 3)
This slot allows you to install an M.2 SSD module.
M.2(SOCKET3)