User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- 3.1 BIOS setup program
- 3.1.1 BIOS menu screen
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Power Management
- 3.3.5 Super IO Configuration
- 3.3.6 Serial Console Redirection
- 3.3.7 SATA Configuration
- 3.3.8 Network Stack Configuration
- 3.3.9 USB Configuration
- 3.3.10 NVMe Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 APM Configuration
- 3.3.13 EZ-Flash
- 3.3.14 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- 3.1 BIOS setup program
- Appendix
H610T-EM-A
2-16
2.6.2 Internal connectors
1. ATX Power connector (4-pin DC_PWR2)
Correctly orient the ATX power supply plugs into these connectors and push
down rmly until the connectors completely t.
PIN 1
DC_PWR2
DC_IN
DC_IN
GND
GND
CAUTION! Do not forget to connect the fan cables to the fan headers.
Insufcient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
headers!
2. CPU and Chassis Fan headers (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan headers on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the header.
CHA_FAN
CPU_FAN
CHA FAN PWM
CHA FAN IN
+12V
GND
A
B
A
B
GND
+12V
CPU FAN IN
CPU FAN PWM
PIN 1
PIN 1
Connector type
WAFER HD 4p, 2.54mm pitch, S/T
CAUTION! To avoid potential damage or system instability, do not connect both
the DC power connector and the ATX Power connector simultaneously.