User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- 3.1 BIOS setup program
- 3.1.1 BIOS menu screen
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Power Management
- 3.3.5 Super IO Configuration
- 3.3.6 Serial Console Redirection
- 3.3.7 SATA Configuration
- 3.3.8 Network Stack Configuration
- 3.3.9 USB Configuration
- 3.3.10 NVMe Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 APM Configuration
- 3.3.13 EZ-Flash
- 3.3.14 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- 3.1 BIOS setup program
- Appendix
2-17
Chapter 2: Motherboard information
CAUTION! Never connect a 1394 cable to the USB header. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
3. USB 2.0 headers (10-1 pin USB_56, USB_78)
These headers are for USB 2.0 ports. Connect a USB cable to the header.
The USB headers comply with USB 2.0 specication that supports up to 480
Mbps connection speed.
BA
B
A
PIN 1
PIN 2 PIN 10
USB+5V
USB_P7-
USB_P7+
GND
NC
USB+5V
USB_P8-
USB_P8+
GND
USB_78
USB_56
PIN 1
PIN 2 PIN 10
USB+5V
USB_P5-
USB_P5+
GND
NC
USB+5V
USB_P6-
USB_P6+
GND
Connector type
HEADER 2x5p, K9, 2mm pitch
4. SATA power connector (SATA_PWRCON)
This connector is for the SATA power cable. The power cable plug is
designed to t this connector in only one orientation. Find the proper
orientation and push down rmly until the connector completely ts.
PIN 1
+3V
+3V
+3V
GND
GND
GND
+5V
+5V
+5V
GND
GND
GND
+12V
+12V
+12V
SATA_PWRCON