User Manual

3-8
H610T-EM-A
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard
storage driver to enable advanced Serial ATA features that increases
storage performance on random workloads by allowing the drive to
internally optimize the order of commands.
SATA6G_1/2/3
Allow you to enable/disable the SATA6G_1/2/3 port. Conguration options:
[Disabled] [Enabled]
M.2(SOCKET3)
Allow you to enable/disable the M.2(SOCKET3) slot. Conguration options:
[Disabled] [Enabled]
3.3.8 NetworkStackConguration
Network Stack
This item allows user to disable or enable the UEFI network stack. Conguration
options: [Disabled] [Enabled]
The following two items appear only when you set the previous item to
[Enabled].
Ipv4 PXE Support
This item allows user to disable or enable the Ipv4 PXE Boot support.
Conguration options: [Disabled] [Enabled]
Ipv6 PXE Support
This item allows user to disable or enable the Ipv6 PXE Boot support.
Conguration options: [Disabled] [Enabled]
3.3.9 USBConguration
XHCI Hand-off
This item functions as a workaround for OSes without XHCI hand-off support. The
XHCI ownership change should be claimed by XHCI driver.
Conguration options: [Enabled] [Disabled]
USB Mass Storage Driver Support
Allows you to enable or disable USB Mass Storage Driver Support.
Conguration options: [Disabled] [Enabled]
U32G1_1~4, USB_5~8
Allows you to enable or disable USB ports. Once set to [Disabled], any USB
devices plugged into the connector will not be detected by BIOS or OS.
Conguration options: [Disabled] [Enabled]