User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- 3.1 BIOS setup program
- 3.1.1 BIOS menu screen
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Power Management
- 3.3.5 Super IO Configuration
- 3.3.6 Serial Console Redirection
- 3.3.7 SATA Configuration
- 3.3.8 Network Stack Configuration
- 3.3.9 USB Configuration
- 3.3.10 NVMe Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 APM Configuration
- 3.3.13 EZ-Flash
- 3.3.14 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- 3.1 BIOS setup program
- Appendix
H610T-EM-A
2-20
9. Chassis Intrusion header (4-1 pin_CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a low-level signal
to this connector when a chassis component is installed. The signal is then
generated as a chassis intrusion event.
Connector type
HEADER 4p, K2, 2.54mm pitch
PIN 1
+5VSB_MB
Chassis Signal
GND
CHASSIS
8. Stereo Speaker header
The internal stereo speaker header allows connection to a pair of internal,
low-power speakers for basic system sound capability. The subsystem is
capable of driving both 4Ω 3W speakers at the same time.
SPK_OUT
PIN 1
A_SPK_L-
A_SPK_L+
A_SPK_R+
A_SPK_R-