User`s manual

Chapter 10. Configuring VPN Internet Security Router User’s Manual
98
Figure 10.5. Intranet VPN Policy Configuration on ISR1
Step 1: Configure VPN connection rules
Refer to the section 10.3 Establish VPN Connection Using Automatic Keying to configure VPN policies on
ISR1 using automatic keying.
Step 2: Configure Firewall rules
1. Configure outbound Firewall rule to allow packets from 192.168.1.0/255.255.255.0 to
192.168.2.0/255.255.255.0 without any NAT
2. Configure inbound Firewall rule to allow packets from 192.168.2.0/255.255.255.0 to
192.168.1.0/255.255.255.0 without any NAT.
Table 10.6 and Table 10.7 provide the parameters to be configured for the outbound and inbound Firewall rule
fields. For a general description on configuring any inbound/outbound Firewall rule, please refer to sections 9.3
and 9.4.
Table 10.6. Outbound Un-translated Firewall Rule for VPN Packets on ISR1
Field Value
Type Subnet
Address 192.168.1.0
Source IP
Mask 255.255.255.0
Type Subnet
Address 192.168.2.0
Destination IP
Mask 255.255.255.0
NAT
None
Action
Allow
VPN
Enable
Note: The outbound Un-translated Firewall rule has to be added the existing rule ID 1001.
Table 10.7. Inbound Un-translated Firewall Rule for VPN Packets on ISR1
Field Value
Type Subnet
Address 192.168.2.0
Source IP
Mask 255.255.255.0
Type Subnet
Address 192.168.1.0
Destination IP
Mask 255.255.255.0
NAT
None
Action
Allow
VPN
Enable
10.6.1.2 Configure Rules on Internet Security Router 2 (ISR2)
Step 1: Configure VPN connection rules