User`s manual

Chapter 10. Configuring VPN Internet Security Router Users Manual
100
Field Value
Mask 255.255.255.0
NAT
None
Action
Allow
VPN
Enable
Note: The outbound Un-translated Firewall rule has to be added the existing rule ID 1001.
Table 10.9. Inbound Un-translated Firewall Rule for VPN Packets on ISR1
Field Value
Type Subnet
Address 192.168.1.0
Source IP
Mask 255.255.255.0
Type Subnet
Address 192.168.2.0
Destination IP
Mask 255.255.255.0
NAT
None
Action
Allow
VPN
Enable
10.6.1.3 Establish Tunnel and Verify
Ping continuously from a host in the LAN behind ISR1 to a host in the LAN behind ISR2. The first few
pings might fail. After a few seconds, the host in the LAN behind ISR1 should start getting ping
response.
10.6.2 Extranet Scenario firewall + static NAT + VPN for VPN traffic
In case of the extranet scenario, the networks protected by the Internet Security Routers could be under
different administrative authorities. Hence, there is a possibility that the IP addresses of both networks are in
the same subnet. The typical extranet set up is shown in Figure 10.7.