User`s manual

Chapter 11. Configuring Remote Access Internet Security Router User’s Manual
110
Field Description
User Name Enter a unique User name for the user that you would like to add.
User State Click on the Enable or Disable radio button to enable or disable the user.
Disabling the user will force the user to be disconnected. Further login from
that specific user will be disabled. Enabling the user will allow the specific
user to log in.
Password Enter the User’s password.
Confirm Password Enter the User’s password again for confirmation. Make sure that you enter
the same password as what you entered in the “Password” field.
11.2.2 Access User Group Configuration Page – (Remote Access è User Group)
Figure 11.1. User Group Configuration Page
Log into Configuration Manager as admin, click the Remote Access menu, and then click the User Group
submenu. The User Group Configuration page displays, as shown in Figure 11.2.
Note that when you open the User Group Configuration page, a list of users is displayed at the bottom half of
the configuration page such as those shown in Figure 11.2.
11.2.3 Add a User Group and/or a User
To add a user group and a new user, follow the instructions below:
1. Open the User Group Configuration page (see section 11.2.2 Access User Group Configuration
Page – (Remote Access è User Group)).
2. Select “Add New User Group” from the user group drop-down list.
3. Enter a name into the User Group Name field. Make sure that this name is unique among the
existing groups. Note that the group name is case sensitive. For example, Group1 and group1
are treated as separate groups.
4. Click on the “Enable” or “Disable” radio button in the Group State field to enable or disable this
group.
5. Enter inactivity timeout period. Default is 300 seconds.
User Group
drop
-
down list
User drop
-
down list