User's Manual
3-9
Chapter 3: BIOS setup
Change Settings [IO=3F8h; IRQ=4]
Allows you to select the Serial Port base address. Conguration options: [IO=3F8h;
IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
SerialPort1Conguration
The sub-items in this menu allow you to set the serial port conguration.
Serial Port [On]
Allows you to enable or disable the serial port (COM). Configuration options: [On] [Off]
Change Settings [IO=3F8h; IRQ=4]
Allows you to select the Serial Port base address. Conguration options: [IO=3F8h;
IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
ParallelPortConguration
The sub-items in this menu allow you to set the parallel port conguration.
Parallel Port [On]
Allows you to enable or disable the parallel port (LPT/LPTE). Conguration options:
[On] [Off]
Change Settings [Auto]
Allows you to select an optimal setting for Super I/O devices. Conguration options:
[Auto] [IO=378h; IRQ=5;] [IO=378h; IRQ=5, 6, 7, 9, 10, 11, 12;] [IO=278h; IRQ=5, 6, 7,
9, 10, 11, 12;] [IO=3BCh; IRQ=5, 6, 7, 9, 10, 11, 12;]
Device Mode [STD Printer Mode]
Allows you to select the Printer Port mode. Conguration options: [STD Printer Mode]
[SPP Mode] [EPP-1.9 and SPP Mode] [EPP-1.7 and SPP Mode] [ECP Mode] [ECP
and EPP 1.9 Mode] [ECP and EPP 1.7 Mode]
3.4.3 APM
ErP Ready [Disabled]
Allows BIOS to switch off some power at S4/S5 to get the system ready for
ErP requirement. When enabled, all other PME options will be switched off.
Conguration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
Restore AC Power Loss [Power Off]
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.
Power On By PCI-E [Disabled]
[Disabled] Disables the PCI-E devices to generate a wake-on-LAN feature of the
Intel
®
/Realtek LAN device.
[Enabled] Enables the PCI-E devices to generate a wake-on-LAN feature of the Intel
®
/
Realtek LAN device.