User guide

1-16 Chapter 1: Motherboard Information
11. S/PDIF connector (4-pin SPDIF_OUT1)
This 4-pin connector accomodates a 4-pin S/PDIF out connector for
S/PDIF using a S/PDIF port bracket. Connect the bracket cable to
this connector then install the bracket into a slot opening at the back
of the system chassis.
A7S266-VM
®
A7S266-VM Digital Audio Connector
+5V
SPDIFOUT
GND
SPDIF_OUT1
10. infrared connector (10-pin IR_CON1)
These connectors support an optional wireless transmitting and
receiving infrared module. The module monts to a small opening on
the system chassis that supports this feature. You must also
configure the UART2 Use As parameter in BIOS to set UART2 for
use with IR. Use the ten pins as shown in Back View and connect a
ribbon cable from the module to the motherboard IR_CON1
connector according to the pin definitions.
A7S266-VM
®
Front View Back View
+5V
IRTX
IRRX
(NC)
GND
+5V
IRRX
IRTX
GND
IR_CON1
1
A7S266-VM Infrared Module Connector
The S/PDIF module is not included in the package.