User guide

2-24 Chapter 2: Hardware information
Required IDE Configuration settings in BIOS
Refer to the following table for the appropriate BIOS settings of the above
P-ATA and S-ATA device configurations. See section “4.3.6 IDE
Configuration” for details on the related BIOS items.
P4C800
®
P4C800 SATA RAID Connectors
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA_RAID1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA_RAID2
4. Serial ATA RAID connectors (7-pin SATA_RAID1, SATA_RAID2)
(on RAID models only)
These Serial ATA connectors support SATA hard disks that you may
configure as a RAID set. Through the onboard Promise PDC20378
RAID controller, you may create a RAID0, RAID1, RAID0+1, or multi-
RAID configuration together with the RAID ATA133 connector. See
Chapter 5 for details on RAID configuration.
If you wish to create a RAID set, make sure that you have connected
the SATA cable and installed Serial ATA devices. You cannot enter the
SATARaid™ utility and SATA BIOS setup during POST if there are no
connected Serial ATA devices.
Windows Windows 98/Me/NT4.0
BIOS item 2000/XP A B C
Onboard IDE Operate Mode Enhanced Mode Compatible Mode Compatible Mode Compatible Mode
Enhanced Mode Support On S-ATA — — —
IDE Port Settings — Primary P-ATA+S-ATA Sec. P-ATA+S-ATA P-ATA Ports Only