User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Powering Up
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 APM Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 T1s Auth
- 4.5.16 Third-party UEFI driver configurations
- 4.5.17 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-9
Overclocking [Disabled]
Enable this item to increase the CPU’s clock. Please use an external PCIe storage controller
for your hard drives when enabling this feature.
Configuration options: [Disabled] [Enabled]
Please note that overclocking might cause component damage or system crashes, which
may reduce the lifespan of the system and the CPU. Use this tool at your own risk.
The following item appears only when Core Optimizer is set to [Disabled], or if Optimized
Performance Setting is set to [Default] or [By Benchmark].
Power Balancer [Disabled]
Allows you to dynamically adjust the frequency of all CPU cores based on their
current utilization, delivering better performance per watt for improved system energy
efficiency.
Configuration options: [Disabled] [Enabled by ACC]
When setting Power Balancer to [Enabled by ACC], make sure that you have the latest
ASUS Control Center software installed to support Power Balancer. Please see below for
recommended software versions:
- ACC: 1.4.3.5 version or above.
The following item appears only when Power Balancer is set to [Enabled by ACC].
Policy [Auto]
Configuration options: [Auto] [Manual]
The following item appears only when set Policy is set to [Manual].
CPU Max frequency [XXXX]
The default value for this option will be the maximum supported frequency of
the CPU installed and may vary between different CPUs.