User Manual
● Onboarding NVM Configurations for LOM (Thor)
● 200G PAM-4 Support
● NVMe/TCP Support (VMWare cert)
● Method to control the activation of the attestation feature
● Enable "Filter Mode" for non-PTP packets
● Generic UCX - GA Support
● Live patching for Whitney+
● Validation of SyncE on Thor B2 Silicon
● Add support for simultaneous update of NICs
● Adaptive Interrupt Coalescing Enhancements
● Enhancement for Linux Default Number of Queues
● NPAR 1.2 Phase I - GA Support
● Feature simplification for Thor and Wh+
● NVM parameter simplification for Thor and Wh+
● Netmap Support for Thor
● Deprecate Legacy BIOS configuration for Thor and Wh+
● QoS Enhancements Phase 2 for Thor
● Display KR mode in Supported and Advertised link modes for Thor and Wh+
● SFP28 25Gbps transceivers through QSFP28-to-SFP28 adapter support for Thor
● Deprecate Live firmware upgrade feature for Thor and Wh+ (NEW)
● Netmap Support with Jumbo Frames
● Enhance ARM Support for Thor and Wh+
● Enable Transmit Packet Steering (XPS) by default on Thor and Wh+ (NEW)
● Multi-host platform support with N2100G (NEW)
● NIC thermal threshold and shutdown logging and handling by host driver (NEW)
● PLDM for FRU Data (DSP0257) support (NEW)
Supported Devices
This release of software supports:
● Broadcom BCM57412 NetXtreme-E 10Gb Ethernet Controller
● Broadcom BCM57414 NetXtreme-E 10Gb/25Gb/40Gb/50Gb Ethernet Controller
● Broadcom BCM57416 NetXtreme-E 10GBASE-T Ethernet Controller
● Broadcom BCM57502 NetXtreme-E 10Gb/25Gb/50Gb Ethernet Controller
● Broadcom BCM57504 NetXtreme-E 25Gb/50Gb/100Gb Ethernet Controller
● Broadcom BCM57508 NetXtreme-E 25Gb/50Gb/100Gb/200Gb Ethernet Controller
Supported Cables
Please refer to the following guide for the list of supported cables and transceivers:
Supported Cables for Broadcom Ethernet Network Adapters