User Guide

1-26 Chapter 1: Product Introduction
K8V-VM System Panel Connector
r
R
K8V-VM
F_PANEL
PLED- PWR PLED+
Ground
GNDReset
IDELED+
IDELED-
HD LED RESET
PLED PWRSW
10. System panel connector (10-1 pin F_PANEL)
This connector supports several system chassis-mounted functions.
•
System power LED (2-pin PLED)
This 3-pin connector is for the system power LED. Connect the chassis power
LED cable to this connector. The system power LED lights up when you turn
on the system power, and blinks when the system is in sleep mode.
•
Power/Soft-off button (2-pin PWRSW)
This connector is for the system power button. Pressing the power button
turns the system ON or puts the system in SLEEP or SOFT-OFF mode
depending on the BIOS settings. Pressing the power switch for more than
four seconds while the system is ON turns the system OFF.
• Hard disk drive activity (2-pin HDLED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The IDE LED lights up or ashes when data is
read from or written to the HDD.
•
Reset button (2-pin RESET)
This connector is for the chassis-mounted reset button for system reboot
without turning off the system power.