Network Card User Manual

Chapter 3 Configuring the ASUS LS99 15
3. Configuration
SCSI Select Options Available Settings Default Setting
SCSI Bus Interface Definitions
SCSI Controller ID 0-15 7
SCSI Controller Parity Enabled Disabled
Disabled
SCSI Controller Termination: Ch. A
1
Enabled Enabled
Disabled
Ch. B Enabled Enabled
Disabled
Y Type Connection
(Termination Disabled)
®
®
Normal Connection
(Termination Enabled)
®
OR
Additional Options
Boot Device Configuration
Boot SCSI Controller AIC-7899 A at slot 00 02:0D:00 AIC-7899 A at slot 00 02:0D:00
AIC-7899 B at slot 00 02:0D:01
Boot SCSI ID 0-15 0
Boot LUN Number
2
0-7 0
SCSI Device Configuration
Sync Transfer Rate (MBytes/sec) 160, 80.0, 53.4, 40.0, 160
32.0, 26.8, 20.0,
16.0, 13.4, 10.0,
ASYN
Initiate Wide Negotiation Yes, No Yes (Enabled)
Enable Disconnection Yes, No Yes (Enabled)
Send Start Unit Command Yes, No Yes (Enabled)
BIOS Multiple LUN Support
3
Yes, No No (Disabled)
Include in BIOS Scan
3
Yes, No Yes ( Enabled)
Advance Configuration
Reset SCSI Bus at IC Initialization Enabled, Disabled Enabled
Display <Ctrl> <A> Messages During Enabled, Disabled Enabled
BIOS Initialization [Auto-sync]
Extended Int 13 Translation for Enabled, Disabled Enabled
DOS Drives > 1 GByte
POST Display Mode [Auto-sync] Verbose, Silent, Diagnostic Verbose
SCSI Controller Int 13 Support Enabled, Disabled:NOT scan, Enabled
Disabled:scan bus
Domain Validation
3
[Auto-sync] Enabled, Disabled Enabled
Support Removable Disks Under Int 13 Disabled, Disabled
as Fixed Disks
3
Boot Only,
All Disks
BIOS Support for Bootable CD-ROM
3
Enabled, Disabled Enabled
Boot Channel [Auto-sync] A First, B First A First
Boot SCSI ID [Auto-sync] 0-15 0
Boot LUN Number
2
[Auto-sync] 0-7 0
1
Leave this on its default setting.
2
Setting is valid only if Multiple LUN Support is enabled.
3
Settings are valid only if host adapter BIOS is enabled.