Network Card User Manual

16 Chapter 3 Configuring the ASUS LS99
3. Configuration
3.2.1 Starting SCSI Select
Follow these steps to start SCSISelect:
1. Turn on or restart your computer.
During the startup process, pay careful attention to the messages that appear on
your screen.
2. When the following message appears on your screen, press the <Ctrl>+<A>
keys simultaneously (this message appears for only a few seconds):
Press <Ctrl><A> for SCSISelect (TM) Utility!
3. Select SCSI Channel A or B. Most SCSISelect options can be set separately for
each SCSI channel.
4. From the menu that appears, use the arrow keys to move the cursor to the option
you want, then press <Enter>.
NOTE: If you have difficulty viewing the display, press <F5> to toggle
between color and monochrome modes. (This feature may not work
on some monitors.)
3.2.2 Exiting SCSI Select
Follow these steps to exit SCSISelect:
1. Press <Esc> until a message prompts you to exit (if you changed any settings,
you are prompted to save the changes before you exit).
2. At the prompt, select Yes to exit, then press any key to reboot the computer. Any
changes you made in SCSISelect take effect after the computer boots.
3.2.3 Using SCSI Select Settings
To select an option, use the arrow keys to move the cursor to the option, then press
<Enter>. In some cases, selecting an option displays another menu. You can return
to the previous menu at any time by pressing <Esc>.
To restore the original SCSISelect default values, press <F6> from the main
SCSISelect screen.
SCSI Bus Interface Definitions
• SCSI Controller ID—(Default: 7) Sets the SCSI ID for the SCSI card. The ASUS
LS99 SCSI card is set to 7,which gives it the highest priority on the SCSI bus.
We recommend that you do not change this setting.
• SCSI Controller Parity (Default: Enabled) When set to Enabled, verifies the
accuracy of data transfer on the SCSI bus. Leave this setting enabled unless any
SCSI device connected to the ASUS LS99 SCSI card does not support SCSI
parity.
• SCSI Controller Termination (Default: Enabled) Determines the termination
setting for the SCSI card. The default setting is Enabled.