Owner manual

1-34 Chapter 1: Product introduction
10. JMicron
®
JMB363 Serial ATA connector (7-pin SATA_RAID1
[black])
This connector is for a Serial ATA signal cable for a Serial ATA hard
disk drive that you can combine with an external Serial ATA 3.0 Gb/s
device to congure a RAID 0, and RAID 1 set through the onboard
Jmicron
®
JMB363 SATA RAID controller. Refer to Chapter 5 for details
on how to set up Serial ATA RAID congurations.
The JMicron
®
RAID Controller item in the BIOS is set to [IDE] by default.
Set to [Raid] to use the connector to build a RAID set. See section
“2.4.5 Onboard Device Conguration” for details.
R
M2N-VM DH
M2N-VM DH SATA RAID Connector
SATA_RAID1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND