Owner's manual

1-24 Chapter 1: Product introduction

3. Keyboard power (3-pin KBPWR)

This jumper allows you to enable or disable the keyboard wake-up feature.

Set this jumper to pins 2-3 (+5VSB) to wake up the computer when you press

a key on the keyboard (the default is the Space Bar). This feature requires an

ATX power supply that can supply at least 500 mA on the +5VSB lead, and a

corresponding setting in the BIOS.

M2N-VM SE

4. PCIE controller setting (3-pin PCIE_SW)

This jumper allows you to enable the onboard DVI device or PCIE x 1 or

x4 device on your PCIEx16 slot. Set this jumper to pins 1-2 to enable the

onboard DVI, or to pins 2-3 to enable the PCIE x 1 and x 4 device on your

PCIEx16 slot.

M2N-VM SE