User's Manual
2-22
Chapter 2: Hardware information
14. Optical S/PDIF Out port. This port connects an external audio output device
via an optical S/PDIF cable.
15. Coaxial S/PDIF Out port.
This port connects an external audio output device
via a coaxial S/PDIF cable.
16. PS/2 keyboard port (purple)
. This port is for a PS/2 keyboard.
For Wireless Edition only:
Please refer to the wireless user guide for detail conguration and settings.
17. Wireless LAN port
. This port is on the onboard wireless LAN module that
allows you to set up a wireless network and exchange information with other
wireless devices without tangling cables and wires. Connect the moveable
omni-directional antenna to this port.
18.
Wireless LAN Activity LED. The wireless module comes with an activity
LED.
• DO NOT insert a different connector to this port.
• DO NOT unplug the external Serial ATA box when a RAID 0 or JBOD is
congured.
• Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cable and installed Serial ATA hard
disk drives; otherwise, you cannot enter the Silicon Image RAID utility and
SATA BIOS setup during POST.
• If you intend to create a RAID conguration using this connector, set the
Silicon 3132 Controller item in the BIOS to [RAID Mode]. See section “4.4.7
Onboard Device Conguration” for details.
• Use these ports and an external Serial ATA box connected to the external
SATA port, if you want to congure a RAID 0, 1 or JBOD set.
• The Serial ATA port multiplier and external Serial ATA box are purchased
separately.