Instruction Manual
Table Of Contents
- Contents
- Chapter 1 Product introduction
- Chapter 2 BIOS setup
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 AI Overclocking [Auto]
- 2.4.2 DRAM Frequency Control [Auto]
- 2.4.3 HT Link Speed [Auto]
- 2.4.4 CPU Voltage [Auto]
- 2.4.5 CPU/NB Voltage [Auto]
- 2.4.6 CPU VDDA Voltage [Auto]
- 2.4.7 DRAM Voltage [Auto]
- 2.4.8 HT Voltage [Auto]
- 2.4.9 NB Voltage [Auto]
- 2.4.10 CPU/LDT Spread Spectrum [Disabled]
- 2.4.11 PCIE Spread Spectrum [Disabled]
- 2.4.12 SATA Spread Spectrum [Disabled]
- 2.4.13 PCI Spread Spectrum [Disabled]
- 2.5 Advanced menu
- 2.6 Power menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
10. USB connectors (10-1 pin USB56, USB78, USB910, USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specication that supports up to
480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
11. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for a Floppy Disk Drive (FDD) signal cable. Insert one end of the
cable to this connector, then connect the other end to the signal connector at the back
of the oppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using an
FDD cable with a covered Pin 5.
• The Floppy Disk Drive signal cable is purchased separately.
1-24
ASUS M4N78 PRO