User’s Manual
Table Of Contents
- 本マニュアルについて
- Chapter 1: ハードウェアのセットアップ
- Chapter 2: ノートPCを使用する
- Chapter 3: Windows® 10環境で使用する
- Chapter 4: Power-On Self-Test (POST)
- Chapter 5: FAQとヒント
- Chapter 6: 付録
- 内蔵モデムの適応規格 (規格/プロトコルなど原文掲載)
- Network Compatibility Declaration
- Non-Voice Equipment
- Federal Communications Commission Interference Statement
- FCC Radio Frequency (RF) Exposure Caution Statement
- CE Mark Warning
- Wireless Operation Channel for Different Domains
- France Restricted Wireless Frequency Bands
- UL Safety Notices
- Power Safety Requirement
- TV Notices
- REACH
- Macrovision Corporation Product Notice
- Nordic Lithium Cautions (for lithium-ion batteries)
- Optical Drive Safety Information
- CDRH Regulations
- CTR 21 Approval (for Notebook PC with built-in Modem)
- ENERGY STAR complied product
- Simplified EU Declaration of Conformity
- 電気・電子機器に含有される化学物質の表示について 
- 回収とリサイクルについて
- 筐体のコーティングについて
- 日本国内での無線周波数帯のご利用について
- 聴覚障害を防ぐため
86 ノートPC ユーザーマニュアル
Federal Communications Commission
Interference Statement
This device complies with FCC Rules Part 15. Operation is subject to the
following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the Federal Communications
Commission (FCC) rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! The use of a shielded-type power cord is required in
order to meet FCC emission limits and to prevent interference
to the nearby radio and television reception. It is essential that
only the supplied power cord be used. Use only shielded cables
to connect I/O devices to this equipment. You are cautioned that
changes or modications not expressly approved by the party
responsible for compliance could void your authority to operate
the equipment.
(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993.
Washington DC: Oce of the Federal Register, National Archives and
Records Administration, U.S. Government Printing Oce.)