User's Manual
2-14
第二章:BIOS 資訊
Active CPU Cores [Auto]
本項目可讓您手動開啟或關閉一個處理器核心。設定值有:[Auto] [Manual]
2nd / 3rd / 4th Core [On]
僅當 Active CPU Cores 設定為 [Manual] 時,本項目才會出現。設定值有:
[On] [Off]
Value (All Cores) [-2%]
僅當 Advanced Clock Calibration 設定為 [All Cores] 時,本項目才會出現,可讓
您將所有處理器核心視為一個整體,來設定超頻百分比。設定值有:[0%] [+2%]
[+4%] [+6%] [+8%] [+10%] [+12%] [-2%] [-4%] [-6%] [-8%] [-10%] [-12%]
Value (Core 0) / (Core 1) / (Core 2) / (Core 3) [-2%]
僅當 Advanced Clock Calibration 設定為 [Per Core] 時,本項目才會出現,可
讓您單獨設定每個處理核心的超頻百分比。設定值有:[0%] [+2%] [+4%] [+6%]
[+8%] [+10%] [+12%] [-2%] [-4%] [-6%] [-8%] [-10%] [-12%]
2.4.3 晶片組設定(Chipset)
北橋設定(NorthBridge Configuration)
記憶體設定(DRAM Controller Configuration)
Bank Interleaving [Auto]
開啟 bank memory interleaving 功能。設定值有:[Disabled] [Auto]
Channel Interleaving [Auto]
開啟 channel memory interleaving 功能。設定值有:[Disabled] [Address bits
6] [Address bits 12] [Auto] [XOR of Address bits [20:16, 6]] [XOR of Address bits
[20:16, 9]]
Enable Clock to All DIMMs [Disabled]
開啟或關閉所有記憶體的時脈功能。設定值有:[Enabled] [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
開啟或關閉 MemClk Tristate C3/ALTVID。設定值有:[Disabled] [Enabled]
Memory Hole Remapping [Enabled]
開啟或關閉 memory hole 周圍記憶體重映射(Memory Remapping)功能。設
定值有:[Disabled] [Enabled]
DCT Unganged Mode [Always]
選擇 Unganed DRAM 模式(64-bit 頻寬)。設定值有:[Auto] [Always]
Power Down Enable [Disabled]
開啟或關閉 DDR power down 模式。設定值有:[Disabled] [Enabled]