User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-3
Chapter 2: Motherboard information
Connectors/Jumpers/Slots
Page
1. ATX Power connector (4-pin DC_PWR2) 2-14
2. USB 3.2 Gen 1 header (20-1 pin U32G1_34) 2-13
3. Built-in Intel
®
Celeron
®
Quad-core
Processor N100 2-4
4. DDR4 SO-DIMM slot 2-4
5. LVDS Panel Backlight Enable Signal Selection jumper (3-pin BKLTEN_SEL) 2-8
6. LCD Panel Monitor Switch header (2-pin PANEL_SW) 2-18
7. LVDS Backlight Panel header (5-pin LCD_BLKT_PANEL) 2-17
8. LVDS Panel VCC Power Selection jumper (6-pin VCC_PWR_SEL) 2-7
9. Chassis Fan header (4-pin CHA_FAN) 2-13
10. Clear RTC RAM (2-pin CLRTC) 2-6
11. LVDS Signal header (40-pin LVDS_EDP) 2-18
12. M.2 socket 3 2-15
13. SATA ports (7-pin SATA6G_1, SATA6G_2) 2-17
14. SATA Power connectors (4-pin SATA_PWR1, SATA_PWR2) 2-21
15. System Panel header (10-1 pin F_PANEL) 2-16
16. Chassis Intrusion header (4-1 pin CHASSIS) 2-13
17. Speaker header 2-23
18. Serial Port headers (10-1 pin COM4-6) 2-20
19. General Purpose Input/Output connector (10-pin GPIO_CON) 2-23
20. COM Debug header (6-1 pin COM_DEBUG) 2-21
21. PCI Express x1 slot 2-24
22. AT/ATX Mode Selection jumper (3-pin AT_ATX_SEL) 2-9
23. Stereo Speaker header (4-pin SPK_OUT) 2-19
24. I
2
C header (6-1 pin I2C) 2-22
25. Front Panel Audio header (10-1 pin F_AUDIO) 2-19
26. RTC Battery connector 2-22
27. TPM header (14-1 pin TPM) 2-20
28. COM1 Ring/+5V/+12V Selection jumper (6-pin COM1_SEL) 2-10
29. USB 2.0 header (5-1 pin USB_7) 2-14
30. M.2 Wi-Fi 2-15