User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
N100I-EM-A
2-14
CAUTION! Never connect a 1394 cable to the USB headers. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
3. USB 2.0 header (5-1 pin USB_7)
This header is for USB 2.0 ports. Connect the USB cable to this header. The
USB header complies with USB 2.0 specication that supports up to 480
Mbps connection speed.
USB_7
PIN 1
GND
S_USB_PP7
S_USB_PN7
+5V_USB_P567
Connector type
Header 1x5p, K5, 2.54mm pitch
4. ATX Power connector (4-pin DC_PWR2)
Correctly orient the ATX power supply plug into this connector and push
down rmly until the connector completely ts.
PIN 1
DC_PWR2
DC_PWR
DC_PWR
GND
GND
CAUTION! DO NOT connect the DC_PWR2 to a power source unit and the
DC_PWR1 to a power adapter simultaneously.