User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-6
N100I-EM-A
Power Limit 1
Allows you to configure Power Limit 1 value in milliwatts.
Power Limit 2 Override
Allows you to enable or disable Power Limit 2 Override.
Configuration options: [Enabled] [Disabled]
NOTE: The following item appears only when you set Power Limit 2
Override to [Enabled].
Power Limit 2
Allows you to configure Power Limit 2 value in milliwatts.
3.3.5 Graphics Configuration
This item allows you to select a primary display from IGFX and PEG graphical
devices.
Primary Display
Allows you to select which of the IGFX/PEG Graphics devices should be the
primary display or select SG for switchable Gfx.
Configuration options: [FORCE] [Auto] [IGFX] [PEG Slot]
Internal Graphics
Configuration options: [Disabled] [Enabled]
[Disabled] Disables internal graphics.
[Enabled] Enables internal graphics.
RC6 (Render Standby)
Allows you to enable or disable render standby support.
Configuration options: [Disabled] [Enabled]
3.3.6 PCI Express Configuration
This item allows you to configure PCI Express settings.
PCIEX1(G3) Slot
Allows you to configure the PCI Express Root Port settings.
PCI Express Root Port 1
Allows you to enable or disable the PCI Express Root Port.
Configuration options: [Disabled] [Enabled]
PCIe Speed
Allows you to configure the PCIe speed.
Configuration options: [Auto] [Gen1] [Gen2] [Gen3]
Detect Timeout
Allows you to set the time (milliseconds) of waiting for link to exit Detect state