User's Manual

iGPU Memory [64M]
Allows you to select the pre‑allocated or xed graphics memory size for DVMT 5.0
used by the IGD. Conguration options: [32M] [64M] [96M] [128M] [160M] [192M]
[224M] [256M] [288M][320M] [352M] [384M] [416M] [448M] [480M] [512M]
PUNIT Power Configuration [Enabled]
Enables or disables the Punit Power conguration. Conguration options: [Enabled]
[Disabled]
Svid Configuration [Svid Config 3]
Allows you to select the SVID conguration. Conguration options: [Svid Cong 0]
[Svid Cong 1] [Svid Cong 3]
2.5.4 SATA Configuration
STAT Controller [Enabled]
Allows you to enable or disabled the SATA device. Conguration options: [Disabled]
[Enabled]
The following items appear only when you set the STAT Controller item to [Enabled].
SATA Mode Selection [AHCI]
Allows you to set the SATA conguration.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advanced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the
drive to internally optimize the order of commands.
Aggressive LPM Support [Auto]
This item appears only when you set the previous item to [AHCI] and allows you to
enable or disable PCH entering link power state aggressively. Conguration options:
[Auto] [Disabled] [Enabled]
S.M.A.R.T. Status Check [On]
S.M.A.R.T. (Self‑Monitoring, Analysis and Reporting Technology) is a monitor system.
When read/write of your hard disk errors occur, this feature allows the hard disk to
report warning messages during the POST. Conguration options: [On] [Off]
SATA6G_1 / SATA6G_2 (Gray)
Allows you to enable or disable the SATA port. Conguration options: [Disabled] [Enabled]
The following items appear only when you set the SATA6G_1 / SATA6G_2 item to
[Enabled].
Hot Plug [Disabled]
Allows you to enable or disable the SATA Hot Plug Support. Conguration options:
[Disabled] [Enabled]
2-16 Chapter 2: Getting started