User's Manual

1-16
Chapter 1: Product introduction
11. Flat panel display brightness (8-pin LCD_BLKT_PANEL)
ThisconnectorisfortheLCDpanelbrightnesscontrols.
N3050I-C
N3150I-C / N3050I-C Flat panel display brightness
PIN 1
BKLT_EN
BKLT_PWM
BKLT_PWR BKLT_PWR
BKLT_GND/Brightness_GND BKLT_GND/Brightness_GND
Brightness_up
Brightness_Down
LCD_BLKT_PANEL
N3150I-C
12. Display panel power connector (2-pin PANEL_SW)
This connector is used for the display panel power switch.
N3050I-C
N3150I-C / N3050I-C Display panel power connector
PIN 1
GND
MON_SW#
PANEL_SW
N3150I-C
10. Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2)
TheseconnectorsconnecttoSerialATA6.0Gb/sharddiskdriveoropticaldrivevia
SerialATA6.0Gb/ssignalcables.
SATA6G_1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA6G_2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
N3050I-C
N3150I-C / N3050I-C SATA 6.0Gb/s connectors
N3150I-C
• TocongurethedefaultSATAtypeinBIOS,clickAdvanced Mode > Advanced tab >
SATA Conguration > SATA Mode.
• Whenusinghot-plugandNCQ,setthe SATA ModeitemintheBIOSto[AHCI].See
section 2.5.4 SATA Conguration for details.