User's Manual
Pre-Dened LVDS Panel Type [Auto]
Allows you to congure the LVDS panel used by Internal Graphics Device.
Conguration options: [Auto] [640x480] [800x600] [1024x768] [1280x1024]
[1400x1050(RB) LVDS1] [1400x1050 LVDS2] [1600x1200 LVDS] [1366x768 LVDS]
[1680x1050] [1920x1200] [1440x900 LVDS] [1600x900 LVDS] [1024x768 LVDS2]
[1280x800] [1920x1080 LVDS]
EDID Data Source [Flat Panel Display]
Conguration options: [Pre‑dened] [Flat Panel Display]
Screen Brightness [Neutral]
Allows you to set the display brightness. Conguration options: [Dimmest] [Dimmer]
[Dim] [Neutral] [Bright] [Brighter] [Brightest]
Channel Select [Single Channel]
Conguration options: [Dual Channel] [Single Channel]
Mode Select [8bit Mode(JEIDA)]
Conguration options: [8bit Mode(JEIDA)] [8bit Mode(VESA)] [6bit Mode(VESA and
JEIDA)]
Panel Power Sequence Control [Enabled]
Conguration options: [Enabled] [Disabled]
Panel_Vcc ON to Video_Data ON (T8) [20 ms]
Conguration options: [10 ms] [20 ms] [30 ms] [40 ms]
Video_Data ON to BKLT_PWM ON (T9) [250 ms]
Conguration options: [100 ms] [200 ms] [250 ms] [300 ms]
BKLT_PWM ON to BKLT_Enable ON (T10) [15 ms]
Conguration options: [10 ms] [15 ms] [20 ms] [25 ms]
BKLT_Enable OFF to BKLT_PWM OFF (T11) [10 ms]
Conguration options: [5 ms] [10 ms] [15 ms] [20 ms]
BKLT_PWM OFF to Video_Data OFF (T12) [250 ms]
Conguration options: [100 ms] [200 ms] [250 ms] [300 ms]
Video_Data OFF to Panel_Vcc OFF (T13) [20 ms]
Conguration options: [10 ms] [20 ms] [30 ms] [40 ms]
Min Panel_Vcc OFF Time (T15) [600 ms]
Conguration options: [600 ms] [700 ms] [800 ms] [1000 ms]
LVDS Spread Spectrum Control [+/- 0.5% Center Spread]
Conguration options: [Disabled] [+/‑ 0.5% Center Spread] [+/‑ 1% Center Spread]
2.5.4 SATA Conguration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Empty if no SATA device is installed to the corresponding SATA port.
SATA Controller [Enabled]
Allows you to enable/disable the SATA controller. Conguration options: [Disabled] [Enabled]
2-16 Chapter 2: Getting started