User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Platform Trust Technology
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphic Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 Onboard Devices Configuration
- 3.3.13 Watchdog Timer
- 3.3.14 APM Configuration
- 3.3.15 EZ-Flash
- 3.3.16 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
J3455T-IM-A/N3350T-IM-A/N4200T-IM-A
2-8
5. Chassis intrusion header (4-1 pin_CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a low-level signal to this connector
when a chassis component is installed. The signal is then generated as a chassis
intrusion event.
J3455T-IM-A
PIN 1
GND
O_CASEOPEN
+5VSB_ATX
CHASSIS
Connector type
HEADER 4p, K2, 2.54mm pitch
4. COM Ring/+5V/+12V selection (6-pin COM1_SEL)
Setting Pins
12V 1-2
5V 3-4
Ring (Default) 5-6
J3455T-IM-A
RI
(Default)
+5V+12V
COM1_SEL
12 34 56