User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 Trusted Computing
- 4.4.2 PCH Storage Configuration
- 4.4.3 Onboard Devices Configuration
- 4.4.4 ACPI Settings
- 4.4.5 APM Configuration
- 4.4.6 SMART Settings
- 4.4.7 NCT6116D Super IO Configuration
- 4.4.8 NCT6116D HW Monitor
- 4.4.9 Serial Port Console Redirection
- 4.4.10 CPU Configuration
- 4.4.11 AMI Graphic Output Protocol Policy
- 4.4.12 PCI Subsystem Settings
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 SDIO Configuration
- 4.4.16 Platform Trust Technology
- 4.4.17 Security Configuration
- 4.4.18 LFP Configuration
- 4.4.19 Thermal
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
66
Single Board Computer
Resolution
This allows you to set the number of rows and columns supported on
the Legacy OS.
Configuration options: [80x24] [80x25]
Redirection After POST
This setting allows you to specify if Bootloader is selected than Legacy
console redirection.
[Always Enable] Legacy Console Redirection is enabled for
Legacy OS.
[Bootloader] Legacy Console Redirection is disabled before
booting to Legacy OS.
Serial Port for Out-of-Band Management/
Windows Emergency Management Services (EMS)
Console Redirection
Allows you to enable or disable the console redirection feature.
Configuration options: [Disabled] [Enabled]
NOTE: The following item appears only when Console Redirection is
set to [Enabled].
Console Redirection Settings
Out-of-Band Mgmt Port
Microsoft Windows Emergency Management Services (EMS) allows for
remote management of a Windows Server OS through a serial port.
Configuration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6]
Terminal Type
Allows you to set the terminal type for out-of-band management.
Configuration options: [VT100] [VT100+] [VT-UTF8] [ANSI]
Bits per second
Allows you to set the serial port transmission speed.
Configuration options: [9600] [19200] [57600] [115200]