User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 Video Configuration
- 3.3.3 PCH-FW Configuration
- 3.3.4 Trusted Computing
- 3.3.5 CPU Configuration
- 3.3.6 Graphic Configuration
- 3.3.7 PCI Express Configuration
- 3.3.8 SATA And RST Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 Power Management
- 3.3.13 Super IO Configuration
- 3.3.14 Serial Console Redirection
- 3.3.15 Miscellaneous
- 3.3.16 Realtek PCIe GBE Family Controller (MAC:00:E0:4C:68:00:0B)
- 3.3.17 APM Configuration
- 3.3.18 EZ-Flash
- 3.3.19 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-18
N5105I-IM-A
3.5 Security menu
This menu allows a new password to be created or a current password to be changed. The
menu also enables or disables the Secure Boot state and lets the user congure the System
Mode state.
Administrator Password
If you have set an administrator password, we recommend that you enter the
administrator password for accessing the system.
To set an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.
To change an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press
<Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Conrm the password when prompted.
To clear the administrator password, follow the same steps as in changing an
administrator password, but press <Enter> when prompted to create/conrm the
password.
User Password
If you have set a user password, you must enter the user password for accessing
the system. The User Password item on top of the screen shows the default Not
Installed. After you set a password, this item shows Installed.
To set a user password:
1. Select the User Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.