Teaming function for Broadcom NIC User’s Guide
Contents Chapter 1. Introduction .................................................................................................1 1.1 What are BACS2 and BASP? ......................................................................1 Chapter 2. BACS2 Installation and Setting...................................................................2 2.1 How to install BACS2 and BASP? ..............................................................2 2.2 Teaming Function Setting Steps ...................................
Chapter 1 Introduction 1.1 What are BACS2 and BASP? Broadcom Advanced Control Suite 2 (BACS2) is an integrated utility that provides useful information about each Broadcom network adapter that is installed in your server. BACS2 also enables you to perform detailed tests, diagnostics, and analyses on each adapter, as well as to view and modify property values and view traffic statistics.
Chapter 2 BACS2 Installation and Setting 1.2 How to install BACS2 and BASP? 1. 2. Launch NetXtreme Software installation guide. Choose Management application.
1.3 Teaming Function Setting Steps 1.3.1 Step1 Open the Broadcom Advanced Control Suite utility.
1.3.2 Step2 Left-click on the “Tools”, and choose “Create a Team” option.
1.3.3 Step3 Enter a name for the Team and choose a Team Type. Click Next to continue. z Smart Load Balancing and Fail Over Smart Load Balancing provides both load balancing and failover when configured for Load Balancing, and only failover when configured for fault tolerance. z Link Aggregation (IEEE 802.3ad) Link Aggregation is similar to Generic Trunking except that it uses the Link Aggregation Control Protocol to negotiate the ports that will make up the team.
1.3.4 Step4 Choose the available adapters to Load Balance Members or Standby Member. z z Load Balance Members groups the adapter into a Load Balancing team. Standby Member adapter is idle until a failover event (for example, loss of link occurs) while primary member is handling all incoming and outgoing traffic. Tip: Teaming is only fully supported by server controllers, such as Broadcom 5721, 5722 etc.
1.3.5 Step5 Add the adapters to Load Balance Members or Standby Member. Click Apply to continue.
1.3.6 Step6 Click Yes to continue. 1.3.
Reference Chapter 1 Broadcom Corporation: www.broadcom.com Trademark Acknowledgement Broadcom is a registered trademark of Broadcom Corporation. All other brand and product names may be trademarks of their respective companies.
