User Guide

15
NUC13RNGi9, NUC13RNGi7, NUC13RNGi5, NUC13SBBi9, NUC13SBBi7, NUC13SBBi5.
User Guide – July 2023
To remove a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 5.
2. Turn off all peripheral devices connected to the computer. Turn off
the computer and disconnect the power cord.
3. Remove the computer’s side and top chassis covers as per the
instructions in the section 2.0 Open the chassis.
4. Gently push the retaining clips down at each end of the memory
module to get it out of the socket.
5. Holding the module by the edges, lift it away from the socket, and
store it in an antistatic package.
6. Reinstall and reconnect any parts you removed or disconnected to
reach the memory sockets.
7. Replace the computer’s covers and reconnect the power cord as per
the instructions from section 5.0 Close the Chassis.