User Manual

ASUS P/I-P65UP8 User’s Manual 27

III. INSTALLATION

(Connectors)

III. INSTALLATION

7. VGA Connector (16 pin VGACON)

To use the onboard VGA, you must attach the provided VGA cable to this con-

nector and mount the bracket to the system cabinet on a free expansion slot or

remove the bracket and mount to the system cabinet’s serial port opening. The

VGA cable then provides a standard 15-pin D-Sub connector for a monitor.

VGA (Monitor) Connector

Bracket to end approximately 6inch

Orient the red stripe on the

monitor cable with pin 1

TIP: You may also remove the bracket

connectors and mount them directly to

the case to save expansion slot space.

8. VGA Memory Upgrade Sockets

This baseboard comes with 1MB VGA memory. Two sockets are provided to

upgrade the VGA memory to 2MB by adding two EDO DRAM’s.

VGA Memory Sockets

Small indentation on

the chip’s sloped edge

Socket's cut corner

Each chip is 512KB DRAM. T wo chips must be

installed to increase the VGA memory by 1MB.

NOTE: The indentations are shown white for visibility , they are normally black.

Match the small indentation on the chip’ s sloped edge with the socket’ s cut corner .

Place the chip flat and evenly into the socket and press firmly but carefully so that

the chip enters evenly. When installed, the chip should be flush with the socket.