User Manual

28 ASUS P/I-P65UP8 User’s Manual

III. INSTALLATION

(Connectors)

III. INSTALLATION

9. IrDA-compliant Infrared Module Connector (5-pin IR)

This connector supports the optional wireless transmitting and receiving infra-

red module. This module mounts to a small opening on system cases that sup-

port this feature. You must also configure the setting through BIOS setup in

Chipset Features to select whether UART2 is directed for use with COM2 or

IrDA. Use the five pins (as defined by Intel) as shown below (Back View) and

connect a ribbon cable from the module to the baseboard according to the pin

definitions. The ribbon cable that may be supplied may either have five or ten

pins (for other standards). If using a ten-pin ribbon cable, use only the top five

row of the ribbon cable plug.

Infrared Module Connector

For the infrared feature to be available, connect an

infrared module (optional) to the baseboard.

+5V

IRTX

IRRX

GND

Back ViewFront View

IRRX

+5V

IRTX

GND

10. USB Module Connector (10-1 pin USB)

If you want to use the universal serial bus (USB), you need to purchase an exter-

nal connector set. The external connector connects to the 9-pin block.

USB Module Connector

1: USB +5Volt

3: USB Port 1 –

5: USB Port 1 +

7: Ground

9: (no connection)

2: USB +5Volt

4: USB Port 0 –

6: USB Port 0 +

8: Ground

10: (no connection)

910