User Manual

3-16
第三章：BIOS 程序設置
第三章
自行更改數值將會導致系統的不穩定與硬件損壞，當系統出現不穩定的
狀況時，推薦您使用默認值。
DRAM Timing Control
本項目可讓您設置 DRAM timing 控制功能，您可以使用 <+> 與 <-> 鍵調整數值。
當您要恢復默認值時，請使用鍵盤輸入 <auto> 並按下 <Enter> 鍵。
Primary Timings
DRAM CAS# Latency [Auto]
設置值有：[Auto] [1] – [31]
DRAM RAS# to CAS# Delay [Auto]
設置值有：[Auto] [1] – [31]
DRAM RAS# ACT Time [Auto]
設置值有：[Auto] [1] – [63]
DRAM COMMAND Rate [Auto]
設置值有：[Auto] [1] – [2]
Secondary Timings
DRAM RAS# to RAS# Delay L [Auto]
設置值有：[Auto] [1] – [15]
DRAM RAS# to RAS# Delay S [Auto]
設置值有：[Auto] [1] – [15]
DRAM REF Cycle Time [Auto]
設置值有：[Auto] [1] – [1023]
DRAM Refresh Interval [Auto]
設置值有：[Auto] [1] – [32767]
DRAM WRITE Recovery Time [Auto]
設置值有：[Auto] [1] – [31]
DRAM READ to PRE Time [Auto]
設置值有：[Auto] [1] – [15]
DRAM FOUR ACT WIN Time [Auto]
設置值有：[Auto] [1] – [63]
DRAM WRITE to READ Delay [Auto]
設置值有：[Auto] [1] – [15]
DRAM WRITE to READ Delay L [Auto]
設置值有：[Auto] [1] – [15]
DRAM WRITE to READ Delay S [Auto]
設置值有：[Auto] [1] – [15]