User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- Chapter 4: Software Support
- Chapter 5: RAID Support
- 5.1 RAID configurations
- 5.1.1 RAID definitions
- 5.1.2 Installing Serial ATA hard disks
- 5.1.3 Setting the RAID item in BIOS
- 5.1.4 Intel® Rapid Storage Technology enterprise SATA Option ROM Utility
- 5.1.5 Creating a RAID set
- 5.1.6 Deleting a RAID set
- 5.1.7 Resetting disks to Non-RAID
- 5.1.8 Exiting the Intel® Rapid Storage Technology enterprise SATA Option ROM utility
- 5.1.9 Rebuilding the RAID
- 5.1.10 Setting the Boot array in the BIOS Setup Utility
- 5.2 Intel® Rapid Storage Technology enterprise (Windows)
- 5.1 RAID configurations
- Chapter 6: Multi GPU Support
- Appendix
3-36
Chapter 3: BIOS Setup
Chapter 3
3.6.9 APM Configuration
ErP Ready [Disabled]
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Conguration options: [Disabled] [Enabled (S4+S5] [Enabled (S5)]
Restore AC Power Loss [Power Off]
This item allows your system to go to ON state, OFF state, or both states after an AC power
loss. When setting your system to [Last State], it goes to the previous state before the AC
power loss.
Conguration options: [Power Off] [Power On] [Last State]
Power On By PCI-E/PCI [Disabled]
This item allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCI-E LAN cards.
Conguration options: [Disabled] [Enabled]
Power On By RTC [Disabled]
This item allows you to enable or disable the RTC (Real-Time Clock) to generate a wake
event and congure the RTC alarm date. When enabled, you can set the days, hours,
minutes, or seconds to schedule an RTC alarm date.
Conguration options: [Disabled] [Enabled]