User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- Chapter 4: Software Support
- Chapter 5: RAID Support
- 5.1 RAID configurations
- 5.1.1 RAID definitions
- 5.1.2 Installing Serial ATA hard disks
- 5.1.3 Setting the RAID item in BIOS
- 5.1.4 Intel® Rapid Storage Technology enterprise SATA Option ROM Utility
- 5.1.5 Creating a RAID set
- 5.1.6 Deleting a RAID set
- 5.1.7 Resetting disks to Non-RAID
- 5.1.8 Exiting the Intel® Rapid Storage Technology enterprise SATA Option ROM utility
- 5.1.9 Rebuilding the RAID
- 5.1.10 Setting the Boot array in the BIOS Setup Utility
- 5.2 Intel® Rapid Storage Technology enterprise (Windows)
- 5.1 RAID configurations
- Chapter 6: Multi GPU Support
- Appendix
3-30
Chapter 3: BIOS Setup
Chapter 3
3.6.5 PCH Storage Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
Scroll down to display the other BIOS items.
M.2 X1_1 Hyper kit Mode [Disabled]
Disable this option for M.2 devices. Enable this option for “ASUS Hyper kit” card.
Conguration options: [Disabled] [Enabled]
M.2 X1_2 Hyper kit Mode [Disabled]
Disable this option for M.2 devices. Enable this option for “ASUS Hyper kit” card.
Conguration options: [Disabled] [Enabled]
SATA Controller(s) [Enabled]
This item allows you to enable or disable the SATA Device.
Conguration options: [Disabled] [Enabled]