User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Powering Up
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 System Event Log
- 4.4.5 Trusted Computing
- 4.4.6 Redfish Host Interface Settings
- 4.4.7 Onboard LAN Configuration
- 4.4.8 Serial Port Console Redirection
- 4.4.9 Intel TXT Information
- 4.4.10 SIO Configuration
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM (Compatibility Support Module)
- 4.4.15 NVMe Configuration
- 4.4.16 APM Configuration
- 4.4.17 Third-party UEFI driver configurations
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
4-14
Chapter 4: BIOS Setup
The following items appears only when
C-States
is set to
[Enabled]
.
Enhanced C-States [Enabled]
Allows you to enable or disable C11E. Enable this item to allow the CPU to switch to
minimum speed when all cores enter C-State.
Configuration options: [Disabled] [Enabled]
C-State Auto Demotion [C1]
This item allows you to configure the C-state auto demotion.
Configuration options: [Disabled] [C1]
C-State Un-demotion [C1]
This item allows you to configure the C-state Un-demotion.
Configuration options: [Disabled] [C1]
Package C-State Demotion [Enabled]
This item allows you to configure the Package C-State Demotion.
Configuration options: [Disabled] [Enabled]
Package C-State Un-demotion [Enabled]
This item allows you to configure the Package C-state Un-demotion.
Configuration options: [Disabled] [Enabled]
Package C-state Limit [Auto]
This item allows you to select the maximum package C-state limit setting. Setting this item
to CPU Default will leave it to Factory default value. Setting this item to Auto will initialize to
deepest available Package C State Limit.
Configuration options: [C0/C1] [C2] [C3] [C6] [C7] [C7S] [C8] [C9] [C10] [CPU Default] [Auto]
Thermal Monitor [Enabled]
Allows you to enable or disable Thermal Monitoring.
Configuration options: [Disabled] [Enabled]