User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Powering Up
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 System Event Log
- 4.4.5 Trusted Computing
- 4.4.6 Redfish Host Interface Settings
- 4.4.7 Onboard LAN Configuration
- 4.4.8 Serial Port Console Redirection
- 4.4.9 Intel TXT Information
- 4.4.10 SIO Configuration
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM (Compatibility Support Module)
- 4.4.15 NVMe Configuration
- 4.4.16 APM Configuration
- 4.4.17 Third-party UEFI driver configurations
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
ASUS P12R-M Series
4-27
Compliance SOS [Disabled]
If supported by hardware and set to
[Enabled]
, this will force LTSSM to send SKP
Ordered Sets between sequences when sending Compliance Pattern or Modified
Compliance Pattern.
Configuration options: [Disabled] [Enabled]
Hardware Autonomous Width [Enabled]
If supported by hardware and set to
[Disabled]
, this will disable the hardware’s ability
to change link width except width size reduction for the purpose of correcting unstable
link operation.
Configuration options: [Disabled] [Enabled]
Hardware Autonomous Speed [Enabled]
If supported by hardware and set to
[Disabled]
, this will disable the hardware’s ability
to change link speed except speed rate reduction for the purpose of correcting unstable
link operation.
Configuration options: [Disabled] [Enabled]
4.4.12 USB Configuration
Legacy USB Support [Enabled]
[Disabled] USB devices are available only for EFI applications.
[Enabled] Enables the support for USB devices on legacy operating systems (OS).
[Auto] Automatically disables the Legacy USB support if USB devices are not
connected.
XHCI Hand-off [Enabled]
Allows you to enable or disable workaround for OSes without XHCI hand-off support. The
XHCI ownership change should be claimed by XHCI driver.
Configuration options: [Disabled] [Enabled]