User Manual

4-28
Chapter 4: BIOS Setup
4.4.13 Network Stack Configuration
Allows you to configure the network stack configuration.
USB Mass Storage Driver Support [Enabled]
Allows you to enable or disable USB Mass Storage driver support.
Configuration options: [Disabled] [Enabled]
Port 60/64 Emulation [Enabled]
Allows you to enable or disable Port 60/64 Emulation.
Configuration options: [Disabled] [Enabled]
USB hardware delays and time-outs
USB transfer time-out [20 sec]
Allows you to set the time-out value for Control, Bulk, and Interrupt transfers.
Configuration options: [1 sec] [5 sec] [10 sec] [20 sec]
Device reset time-out [20 sec]
Allows you to set the device reset time-out value.
Configuration options: [10 sec] 20 sec] [30 sec] [40 sec]
Device power-up delay [Auto]
Allows you to set the maximum time the device takes before the device reports itself to the
host controller properly.
[Auto]
uses default value; for a Root port it is 100 ms, for a Hub port
the delay is taken from Hub descriptor.
Configuration options: [Auto] [Manual]
The following item appears only when
Device power-up delay
is set to
[Manual]
.
Device power-up delay in seconds [5]
Allows you to set the device power-up delay in seconds. Use the <+> or <-> to adjust
the value. The values range from 1 to 40.
Mass Storage Devices
Allows you to select the mass storage device emulation type for devices connected.
Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CD-ROM]
Network Stack [Enabled]
Allows you to enable or disable UEFI Network Stack.
Configuration options: [Disabled] [Enabled]